Show Posts
1
General Discussion / another problem exporting to pdf
« on: August 18, 2011, 09:32:06 PM »
Hello,
I've run into to a similar problem as some recently where I cannot export from within WinFig as a pdf. WinFig is recognizing the correct Ghostscript location and using
fig2dev.exe -L pdf inputfile.fig outputfile.pdf from the command line works fine. When I try and export from within WInFig it gives me nothing but 0 byte files.
Scott
I've run into to a similar problem as some recently where I cannot export from within WinFig as a pdf. WinFig is recognizing the correct Ghostscript location and using
fig2dev.exe -L pdf inputfile.fig outputfile.pdf from the command line works fine. When I try and export from within WInFig it gives me nothing but 0 byte files.
Scott